Permanent magnets and electric inertial propulsion.

This propulsion is a continuation and development of earlier propulsion solution but in this solution I have changed the manner of setting of the permanent magnets. I will apply magnets placed on their edges and rotating magnets also placed on their edges. This time I have applied different location of permanent magnets to each other. Bar permanent magnets will be set attached side by side they will attract each other creating circumference magnetic rim (120 bar neodymium permanent magnets). There will be also rotating permanent magnets also but with repel polarization to the rim magnets. Such a construction of the system will eliminate the necessity of application of hard to obtain technologically one - piece rim magnet and allow to build much cheaper system from smaller bar magnets. These magnets will be placed in 3D printed holder which will be predicting the slightly inclination of each magnet on circular track. The system as my earlier solution will be powered by electric motor. The system will need to be paired with the same oppositely rotating device, or one should consider applying oppositely rotating circumference neodymium rim magnet in the same mechanically bound system, to obtain more consolidated system. By use of such a solution I can obtain easier to build system but including more magnets. I also considered the application of oppositely rotating rim to balance the system. The balancing ring should be constructed from many smaller magnets due to it is impossible to obtain outside polarization setting on such a polarization while inside would be opposite pole and outside another. The same one could obtain with non-magnetic solution application using several ball bearings or sliding sleeves. The problem of propulsion of this balance is open but I only will add that this balance would be needed only if there will be only one rotor inside this stator, because once we had a doubled or tripled or more complexed rotor system of this kind we won't need the balance any more because the system would be balanced automatically when the particular rotors will be operating in different direction.

The permanent magnets in outer rim are attached side by side and they are merging north pole to south pole each other.